Atlantis Washer And Dryer

Orgullosísimos or orgullosisísimos as they say here are of our trusses, especially since it cost us a lot!!

The design with the support of an engineer from the private University of Piura advised me it scared me that we dropped the ceiling!! We use

screw wood veneer lumber and we use 3 / 16 with bolts 3 / 8 for the connections. More plates have been paraded you can imagine. Purchased in Piura, carried Huancabamba, cut and perforated Huancabamba Chiclayo. To perforate we should use a template, drill the wood and mark the new holes in your partner, take a couple of drill holes to fit them and mark the final holes. That is, the plates were walking at least 2 or 3 times on a motorcycle of the work to the welder.

After zincronato apply a layer to protect from corrosion and two fine enamel colors, maroon, what do you think?

Here I am marking the holes in the wood.

Polo bolting the plates.

Our plate drying stand ---------- All for one and up!!
all joked that it seemed jerky.

assembling trusses and the strength of the boys!

On mounting made tremendous sun, so we just all quemadísimos!

And we became pretty good! Congratulations to trusses, Alfredo and Polo.